Removing Bathtub Caulking

Before applying new caulk around your bathtub shower or sink you must firsts remove the old caulk.

Removing bathtub caulking. In fact using this method you can finish the task in seconds. Removing mildew moldy caulk does not have to be a difficult task. Remove old caulk and clean the surface. And if you get too aggressive you ll chip a tile or mar the tub finish.

Apply a caulk remover such as 3m caulk remover or mckanica silicone caulk remover gel. With patience and plenty of it. Plus a little patience pays off by making the job much much easier. Removing the old caulk as needed and preparing the surfaces is very important for an effective caulk application and repair.

Simplify old moldy caulk removal by applying special caulk remover over the caulk to soften it and break the bond. Before you can re caulk the tub you need to remove the old stuff entirely it can be a time consuming task but it s. Keep the angle of the blade as low as possible and watch the caulking to see if it s being cut. Scraping out moldy caulk from around a bathtub is a tough tedious job.

For caulk joints in corners such as where wall tile meets a tub sink or countertop a caulk. Instead remove the existing caulking using your chosen caulk remover such as goo gone caulk remover available on amazon and a simple putty knife such as hyde s 1 1 2 putty knife also. How to remove bathroom caulk. I suggest you put the lowest dose of heat which will be effective in removing the caulk.

Start by closing the pop up drain in the tub and covering the entire tub with a drop cloth to protect it from scratches residue etc. Now you can use the caulk removal tool like the homax plastic caulk removal tool. Then simply scrape the old caulk away. You should heat up small portions like 10 inches at a go.

Take the razor blade and carefully pry the old caulking off the tub. To prep the surfaces remove the old caulk with a retractable razor blade scraper. Remove old caulk photo by david carmack. Removing old silicone caulking is no picnic no solvent dissolves it and you won t find a magic one step removal tool you ll need a razor knife for cutting and scraping a putty knife and a pair of pliers because pulling the rubbery material with your fingers can be difficult.

The caulk around a bathtub looks pretty nasty when it begins to peel away. New caulk doesn t stick to old caulk so if you fail to remove the old stuff the new caulk can t form a watertight seal leaving the potential for moisture to seep into areas where you don t want it.